Barnet · North London
Wraparound extensionin Hendon.
A wraparound extension is powerful because it changes the side and rear of the house together. That also means the important decision is not just how much floor area to gain, but how to protect the garden, daylight and movement through the home while the new footprint is being drawn.

- Service
- Wraparound extension
- Neighbourhood
- Hendon
- Borough
- Barnet
- Next step
- Discuss your project
Your project brief
Decide what must remain outside as well as inside
Because the extension wraps around two sides, the plan should start by identifying what the home needs to keep: a sensible garden, some separation to boundaries, and a route for people to move comfortably through the ground floor. If too much is taken, the house may end up larger but less pleasant to use.
A possible brief might keep the garden as a clear outdoor room and pull the new interior around it in a controlled way. That can work well when the extension is used to reorganise kitchen, dining and living areas, rather than just pushing the rear wall out until there is no clear relationship with the outside.
Local planning position to check before combining two sides
Barnet notes that some conservation areas have Article 4 Directions and that special controls can apply in conservation areas. Hendon Church End and Hendon The Burroughs are listed by the council, but only an exact-address check can show whether your site is affected. That matters for a wraparound scheme because the larger combined footprint may need a clearer planning position than smaller works.
Design decisions
Treat the openings and roof junctions as part of one system
This form of extension often depends on how existing openings are reused or changed. Keeping some openings can preserve daylight, views and a sense of where the old house ends, while reconfiguring them may produce a more open-plan room with better circulation and a stronger link to the garden.
The roof junctions and structural openings need equal attention. If the side and rear parts are designed separately, the finished result can feel disjointed. When they are coordinated from the start, the house can gain one continuous ground-floor layout rather than two extensions that merely meet at a corner.
Design checks
Four things we confirm before drawing a wraparound extension.
- 01Compare the combined side and rear footprint with the garden retained.
- 02Plan daylight to the centre of the original house.
- 03Coordinate structural openings and the junction between roof elements.
- 04Check the planning route for the combined scheme rather than assuming two separate allowances apply.
Questions
Before you call about Hendon.
Why does a wraparound extension need a different approach from a simple rear extension?
Because it changes the house on two sides at once. That affects garden space, daylight, structural openings and circulation, so the scheme has to be judged as one connected layout rather than as two separate bits of building work.
How do I decide whether to keep some openings instead of replacing them all?
Keep openings that still help with light, views or the feel of the house, and rework only the ones that stop the new layout functioning properly. A mixed approach often gives the best balance between continuity and improvement.
Can this type of extension still leave the home feeling connected to the garden?
Yes, if the design protects a clear outdoor area and uses openings well. The goal is usually to make the inside and outside relate more clearly, not to eliminate the garden in favour of more enclosed floor space.
Planning and project guidance
- Conservation areas | Barnet Council
- GOV.UK · Planning permission
- GOV.UK · Building regulations approval
- GOV.UK · Party walls and building work
Check the current guidance for your address before relying on a planning route. This guide is not a planning decision or a verified local case study.
Other services in Hendon








