Richmond upon Thames · West London
Paintingin Richmond.
A good paint job begins long before the first coat goes on. In Richmond, the main decision is whether the surface is ready for painting at all, or whether it needs filling, stabilising or another trade’s work first so the finish has something sound to sit on.

- Service
- Painting
- Neighbourhood
- Richmond
- Borough
- Richmond upon Thames
- Next step
- Discuss your project
Your project brief
Base the painting plan on surface condition
Paint cannot hide every defect. If the wall is uneven, stained or poorly repaired, a new colour may still leave the room looking tired. The right approach is to judge whether the surface needs minor making good, stain treatment or more substantial plaster repair before coating starts.
That check matters just as much on woodwork and trim. A door frame with damaged edges or old flaking paint needs a different preparation from a smooth surface that only needs a new coat. The more accurate the condition survey, the fewer surprises once the room is open and ready.
Richmond checks before painting outside or altering the front
Richmond upon Thames says any home in the borough can be subject to an Article 4 Direction, and some homes fall within conservation-related controls. That is most relevant where painting is part of an external change, such as rendering or altering the front of the property. Exact address checks are still needed before assuming the work is unrestricted, because borough-wide evidence does not prove every site is covered.
Design decisions
Keep access, coating choice and finish level distinct
Different surfaces need different treatment. Interior walls and ceilings are not handled the same way as doors, skirting or a suitable exterior surface. The scope should say which areas are included, what preparation is required and what finish level is expected. That avoids a vague promise to repaint the room without describing the actual standard.
If the project includes an exterior surface, safe access and weather exposure also matter. The preparation and coating system should suit the material, not just the colour. Separating those decisions in writing helps compare quotes and keeps decorative work from absorbing repairs that belong elsewhere.
Design checks
Four things we confirm before drawing painting work.
- 01Interior walls and ceilings, with the specified preparation and coating system.
- 02Doors, skirting, frames and other agreed timber or trim surfaces.
- 03Suitable exterior surfaces assessed for weather exposure and safe access.
- 04Making good minor defects, with larger plaster repairs identified separately.
What makes preparation so important before painting?
Because paint follows the surface, it does not fix the substrate. If defects, contamination or old failed coatings remain, the finish is more likely to show them again.
Should I treat doors and walls as the same painting job?
No. Timber, trim and walls often need different prep and products, so they should be listed separately in the scope to avoid a mismatch in finish or effort.
When does painting need more than a fresh coat?
When the surface has damage, staining, flaky old paint or an unsuitable finish underneath. In that case, the work may need making good or another trade’s repair first.
Planning and project guidance
- Article 4 Directions - Conservation areas - London Borough of Richmond upon Thames
- GOV.UK · Planning permission
- GOV.UK · Building regulations approval
- GOV.UK · Party walls and building work
Check the current guidance for your address before relying on a planning route. This guide is not a planning decision or a verified local case study.
Other services in Richmond







